I love these clamps. I am anxiously awaiting the day that they have a non-marring version.
I’m was halfway through a run of parts that were fighting me to no end. I switched from a solid carbide 3/4” Dorian bar to an MAQ 3/4" vibration damped with the same parameters. The part on the right in the picture below is the result.
Really appreciate all the help from you guys.
Very soft shirt, graphics are very vivid. I’ve been making better parts because of this shirt
The videos you see online of these bars are the real thing. I've had the same experience in my shop. Just today we machined some parts with a bore 5.5" deep. We used a 3/4" boring bar with a 5.75 stickout. Didn't even change the finishing feeds and speeds from what we would normally run. Roughed and finished with the same bar. It actually broke a chip too! We're willing to do parts that we would have avoided before.
